• Registered: 23-11-2010
  • Posts: 6

Topic: Compile with IML++

Hello,

I am trying to compile oofem-1.9 with IML++ (I extracted IML ++ in both oofem top directory and src directory) however it doesn't work and I end up with the lines:
"IML includes not found in /iml.
Type in directory (use absolute path):"
looping on my terminal.
Can anyone help me with that? Thank you very much.

M.B.

2 Reply by bp

  • bp
  • Administrator
  • Offline
  • From: Prague, Czech Rep.
  • Registered: 02-03-2007
  • Posts: 1,033

Re: Compile with IML++

Hi Michael,

this is probably due to the bad parameters passed to configure script.
When compiling with iml, you should use

./configure .... --enable-iml --with-IMLDIR=path_to_iml

where path_to_iml is full (absolute) path to iml source directory.

Borek

bp's Website

  • Registered: 23-11-2010
  • Posts: 6

Re: Compile with IML++

Ok thanks it works! Sorry, I am useless...

  • From: PARIS
  • Registered: 31-10-2008
  • Posts: 41

Re: Compile with IML++

Hello Mr Borek:

Four years ago I tried to use the OOFEM to the masonry wallets analysis for my doctoral research, unhappy, I had the sufficient time to do. I was in Paris, now-day I returned to my country( Mexico) and I will be the masonry walls analysis under lateral load, so I wait you could help me.
Thanks

  • From: PARIS
  • Registered: 31-10-2008
  • Posts: 41

Re: Compile with IML++

Hello Mr Borek:

Four years ago I tried to use the OOFEM to the masonry wallets analysis for my doctoral research, unhappy, I had the sufficient time to do. I was in Paris, now-day I returned to my country( Mexico) and I will be the masonry walls analysis under lateral load, so I wait you could help me.
Thanks